Can I ask a linux question of somebody here?  I'm a little confused about my networking setup
strange problem.. I install a fresh slack10.2 distro on a new machine.. with my older drive as a secondary slave .. it booted windows98 fine previously(the new hd), so I install fine.. lilo does conk out, but when I go to boot the partition from the boot cd.. it halts and says invalid device @ hda1 (I later booted the sec. slave fine.. ) did my lilo attempt f' up the partition? it mounts fine on the sec. partition boot.. or where else shoul

it just says no ext2/3 .. no /etc/fstab etc. just unrecognizable .. not detected at all
take look at fdisk -l for the drive
seems fine.
did you let it automatically create the lilo.conf
and i don't remember, the fstab
f'n aye.. thanks man.. it's note there..
note/not
on that partition
duh..
thanks
cool